description, operations description, and error reporting
for the Conner Peripheral's model CP3180.
2.0 Key Features
The Conner Peripherals CP3100 is a 3.5 inch disk drive
which offers high performance and capacity
(104 megabytes) with low power consumption. It comes
equipped with an embedded industry standard controller.
Key features include:
o 1:1 Interleave
o Spindle Synchronization
o 32K Byte Read Look Ahead Buffer
o Embedded Servo
o Rotary Voice Coil Actuator
o Track Skewing
o Low Power Consumption
o Automatic Retries
3.0 Specification Summary
3.1 Capacity
104 Mbytes Formatted
3.2 Physical Configuration
Actuator Type Rotary Voice-coil Number of Disks 3 Data Surfaces 6 Data Heads 6 Servo Embedded Tracks per Surface 832 Track Density 1200 TPI Track Capacity 16,896 bytes Bytes per Block 512 Blocks per Drive 164,736 Blocks per Track 33
3.3 Performance:
Seek times Track to Track: 8 ms Average: 25 ms Maximum: 45. ms Rotation Speed (+0.1%) 3575 RPM Data Transfer Rate 1.25 Mbyte/sec Start Time
typical: 15 sec
maximum: 20 sec Stop Time typical: 15 sec
maximum: 20 sec Interleave 1:1 Buffer Size 32K
The timing is measured through the interface with the drive
operating at nominal DC input voltages. The timing also
assumes that any I/O driver overhead and system hardware
dependency have been subtracted from timing measurements.
The average seek time is determined by averaging the seek
time for a minimum of 1000 seeks of random length over the
surface of the disk.
3.4 Read/Write
Interface SCSI Recording Method RLL Code Recording Density (ID) 23,441 BPI Flux Density (ID) 15,627 RPI3.5 Power Requirements (Typical)
+12V DC +5V DC PowerRead/Write Mode 270 ma 380 ma 5.2 WSeek Mode 330 ma 350 ma 5.7 WReady Mode 240 ma 350 ma 4.7 WSpin-up Mode 2.0 A 350 ma N/A+12V DC: The maximum ripple allowed is 1% with equivalent
resistive load.
+5V DC: The maximum ripple allowed is 2% with equivalent
resistive load, without SCSI bus terminators installed.
Read/Write Mode: Occurs when data is being read from or
written to the disk.
Seek Mode: Occurs when the actuator is in motion.
Ready Mode: Occurs when the drive is not reading, writing,
or seeking. The spin motor is up to speed and a Drive Ready
condition exists. The actuator is residing on the last
accessed track.
Spin-up Mode: Current draw is for 7 seconds maximum.
